First of all, ready to install tools, before the installation of the inspection of supporting parts are complete, common faucet parts are: hoses, rubber washers, showers, water, guaizi, decorative caps and so on. 1.Installation of single hole lavatory mixer Buy a single handle basin faucet should pay attention to the diameter of the mouth, the market is mostly hard pipe water, so you should pay attention to reserve the height of the mouth, from the basin down 35 Gongfen the most appropriate. When installing, must choose the special angle valve, but the angle valve must and the wall outlet hot and cold water pipe fixed. When you find the distance between the angle valve and the faucet, go to buy the special lengthened withdrawal connection. Remember, you must not use other pipes to connect, because if the water pressure, it is easy to fall off, leakage, causing you loss. If the intake pipe is too long than the outlet pipe, can be cut off according to your needs, the angle is not suitable for the appropriate bending to the position you need. Remember: Do not bend hard to 90 degrees or greater than 90 degrees. When installing the basin to go to the water, please do not forget to buy the small interface of the faucet (faucet short connect).Please do not forget to flush the water pipe buried in the wall before you install it. 2.Shower, bathtub faucet (hanging wall) installation When you have purchased a shower, bathtub, wall mixer, you can select the appropriate height buried outlet. The distance between hot and cold water pipes must reach 15 cm.Before installing you must not forget to flush the water pipe, lest water quality is perfect, cause damage to the faucet. Dark install shower, bathtub faucet: After buying the dark mounted faucet, the valve core of the faucet is usually embedded in the wall. Be sure to pay attention to the thickness of the bathroom wall before burying. If the wall is too thin, the spool will not be embedded. The plastic protection cover of the spool is not easily removed so as to avoid damage to the spool when the cement and other chores are buried. In addition, the embedded spool should also pay attention to the spool of the upper and lower, left and right direction to avoid the valve core buried wrong.Wall-mounted faucet embedded in the pipe when the size of the deviation can be used to adjust the Guaizi to carry out the school position. 3.Installation of thermostatic faucet Install thermostatic faucet before, please check the water pipe is not Zouge right cold, remember not to install the hot and cold water pipe wrong, lest the faucet can not work properly. Gas, solar water heaters can not use thermostatic faucet, because the pressure is too low.Install thermostatic faucet, please do not forget to install hot and cold water filtration net. 4.
Installation of single-hole kitchen faucet The requirement is stable, because the kitchen faucet uses the frequency to be high, moreover is moved to move, extremely easy to loosen, therefore the lock nut must tighten tightly.On the market there are some faucets for the screw tube to increase the nut fixed, this stable effect is very good, if you can solve the problem of water lifting, will be a popular trend in the future.